I grabbed an LED brake/park light from Hyway Truck Spares at Chipping Norton and gave it a slight trim and fitted it inside the empty tri bar case.
Spliced the wires into the appropriate wires and works good for me.

cost me about $30.

I did exactly that went to super cheap got a 20 dollar led light from there my mate who is a elecy work out where to solder on the board and hey presto LED's in the rear guard!!

You can let them know that there are a number of riders in Aus that will buy their product if they produce an adapter to wire it up.

A lot of riders find it is a waste having the 'fake' light setup without lights.

I look forward to hearing what you find out.

 

Pictures would be nice......

When i get me bike back from the panel beaters i'll get a couple of photos.

Some advice on how to wire up a light to the board would be great.

Any chance of some pics from any of the guys who have installed a light and how they wired it?

 

yes i too would be interested in how it wires in, just bought a new 2015 model couple of months back

Got my beast back, when i get 5 minutes i'll get some pics.

I'll try and get a diagram together to show how we wired ours up.

Any news on pics or a diagram? I am also interested to know if CD has suggested they may cater for the Australian market.

Bump..........Any more updates????

I went to Supercheap and got the $18 red LED as the cheaper SCA lights were out of stock at the local stores. I found the second pin down on the input and bottom pin on the output side of the plate worked as the brake light. a bit hard to solder as not much space between pins but not too difficult. I think I could have fitted more lights into the space but it works well and looks great at night.

Still havent had time to pull it apart and get photos. Sorry lads. I'm currently working on white LEDs in the slotted chrome windscreen fairing trim. The flexible strips work ok but i've run them underneath the trim and it basically crushes them so they dont last too long. Might have to put individual segments in the slots, a lot of mucking around with the wiring. Might be easier to get the genuine one.....

Hello everybody iv been a member on this forum for a long time but i have not been on it due to work and trying to log in was a pain lol
So i had to register with a new name
Reading the forum people really want this tri bar to work and so do i
Iv been a auto electrician for 31 years and last Sunday i decided to look into it
What i found out was the difference from the Australian model HDI and the US model is the out put from the dummy tri bar
Input is the same


If some one wants to talk to me about this
  email me ttgg68@hotmail.com

DOC15

Good work Doc15. Great initiative.

Just goes to show that people with a bit of knowledge and experience can do to problem solve for themselves and everyone else on the forum.

I look forward to hearing about the end result.

Nice doc. If/when custom dynamics get this sorted I'll buy one. Hopefully it'll be a running and brake light setup

Ill be doing the runing light plus brake 

The wires are all ready there going into the dunny light 

Leave it with me

Cheers

im looking forward to this as i cant understand why its just not done in the 1st place

Following
With interest