Who's online: RMAC, gidgi, Spook, goingmad1, Guests: 506
  • twistie Posts: 74
    tas
    Stock Poster twistie
    13 Sep 2018 10:51 PM
    https://www.youtube.com/watch?v=kps82JmgoVg&feature=youtu.be
  • paulybronco Posts: 10323
    Forum Legend paulybronco
    14 Sep 2018 07:03 AM
    There has been several "see through" wheels on custom bikes before . It certainly makes you look hard at it due to the optical illusion
  • paulybronco Posts: 10323
    Forum Legend paulybronco
    14 Sep 2018 07:06 AM
    This is how it rolls....




  • Hilly Posts: 2342
    Townsville
    Motor Head Hilly
    14 Sep 2018 02:09 PM
    Quoting paulybronco on 14 Sep 2018 07:06 AM
    This is how it rolls....




    $10K bearing and he whacks it side on with a dead blow!
  • tussuck Posts: 1463
    Melbourne
    Performance Poster tussuck
    14 Sep 2018 04:18 PM
    Dint those OCC dikheads do a friction drive rear end at some point?  That was a total abortion.
  • paulybronco Posts: 10323
    Forum Legend paulybronco
    14 Sep 2018 08:46 PM
    Quoting paulybronco on 14 Sep 2018 07:06 AM
    This is how it rolls....




    Quoting Hilly on 14 Sep 2018 02:09 PM
    $10K bearing and he whacks it side on with a dead blow!
    Ha Ha i did notice that, but het its going to be your problem when you buy his bike
  • loopie Posts: 336
    Stage 1 Poster loopie
    14 Sep 2018 09:59 PM
    Quoting paulybronco on 14 Sep 2018 07:06 AM
    This is how it rolls....




    Quoting Hilly on 14 Sep 2018 02:09 PM
    $10K bearing and he whacks it side on with a dead blow!
    when ive installed some bearings i freeze the bearing  and  warm crank case      pop in it goes no hammer too fuck a bearing
  • Hilly Posts: 2342
    Townsville
    Motor Head Hilly
    15 Sep 2018 06:46 AM
    Quoting paulybronco on 14 Sep 2018 07:06 AM
    This is how it rolls....




    Quoting Hilly on 14 Sep 2018 02:09 PM
    $10K bearing and he whacks it side on with a dead blow!
    Quoting loopie on 14 Sep 2018 09:59 PM
    when ive installed some bearings i freeze the bearing  and  warm crank case      pop in it goes no hammer too fuck a bearing
    Yep depends on the situation, heat them or freeze them, I have no qualms belting a race in with a copper hammer or brass drift but roller bearings of nearly any type need a bit of care or you will damage them, even if you can't see or feel anything to begin with.
© 2018 - 1.0.4.2